Simulating a measurement update allows you to test the results calculated by the measurement formula without updating the values posted to the scorecard. You can perform a simulation as many times as you want.

  1. Click > > .

  2. To limit the simulation to a specific scorecard, objective, or measurement, click .

  3. In the field, enter a date for the simulation. If you do not enter a date, today's date is used.

  4. Under , select the type of simulation to perform. You can choose from the following options:

    • To simulate an update for all periods that are not yet calculated.

    • – To simulate all periods that lack a value because one transaction has been offset by another.

  5. To start the simulation, click .

  6. To view the transaction information as a graphic, click . One indicator is shown for each simulated transaction.

Note Note

You cannot simulate measurements that have a status.


See Also